Requirements
Charging station installed and powered
Station connected to the internet
Physical access to the charger's touch display
Display settings password (default 88888888)
Connect your charger
On-display configuration:
Confirm the charging station has a working internet connection.
Tap the SETEC logo on the charger display.
Enter the password 88888888.
Tap Charge Point Settings.
Tap Public Setting, then open IP Config.
Activate the Enable OCPP toggle and enter
wss://proxy.plugchoice.com/v1in the OCPP-URL field.In the ID field, set the desired station name, then save. The name can be changed later in the backend.
With OCPP enabled and the Plugchoice URL and ID saved on the display, the station connects to Plugchoice over OCPP.
Registering your charger in Plugchoice
Add the charger using the chargepoint ID. In the ID field on the display, set the desired station name. The source states this identity can be changed later in the backend.
Done! The charger should come online.
Troubleshooting
Did you set everything up correctly, but the charger still remains "Pre-registered"?
For accurate charging-power display, set the meter values upload interval to 30 to 60 seconds via OCPP Get Configuration and Change Configuration.
Contact support
Phone: +8675526527304
Help center: https://www.setecpower.com/services-support/
You can also reach Plugchoice directly: chat with us in the app, or email [email protected].
For a complete guide, see our troubleshooting article if your charger can't connect to Plugchoice.