Requirements
Internet connection for the charger (ethernet, wifi or 4G)
Laptop or phone on the same network as the charger
The web server login and the charger's serial number
Connect your charger
In your browser, open 192.168.204.10.
Log into the web server.
Click the Webmanager tab at the top.
Go to Set up > Communications.
Set up your network connection (SIM, wifi or ethernet).
Set the Web socket URL to
ws://proxy.plugchoice.com/v1/SERIALNUMBER.Replace SERIALNUMBER with the charger's serial number.
Set Enabled Ocpp to on.
Set Timeout Web socket to 120.
Set Notify charger status to on.
Set WebSocketPingInterval to 60.
Set Occupy logical connector to off.
Click Apply, then reset the charger in the System menu.
Registering your charger in Plugchoice
Add the charger using the chargepoint ID. For Power Electronics, this is the serial number (case sensitive).
Done! The charger should come online.
Troubleshooting
Did you set everything up correctly, but the charger still remains "Pre-registered"?
The chargepoint ID must exactly match the serial number.
The serial number must be in the URL, after
/v1/.Reset the charger after applying the settings.
For a complete guide, see our troubleshooting article if your charger can't connect to Plugchoice.