Requirements
A Windows laptop and an ethernet cable
Physical access to the charger controller
Connect your charger
Connect the ethernet cable to the switch underneath the controller.
On your laptop, go to Settings > Network & Internet > Ethernet.
Activate IPv4 and set an IP address between
192.168.2.200and192.168.2.220.
In a browser, go to
http://192.168.2.2:8080/index.html.
Go to Config > Software Properties-RW.
Click the parameter Isk.evse.Cfg.dl.uri.
In Value, enter:
ws://ocpp.plugchoice.com
Go back to the Home page.
In the Status dropdown, select Commands.
Click RESET SW to reboot the charger.
Registering your charger in Plugchoice
Add the charger using the chargepoint ID. For Iskraemeco, this is the charger's serial number (case sensitive).
Done! The charger should come online.
Troubleshooting
Did you set everything up correctly, but the charger still remains "Pre-registered"?
The chargepoint ID in Plugchoice must exactly match the serial number.
Can't reach the web interface? Re-check your laptop's IP address.
Check the Isk.evse.Cfg.dl.uri value for typos.
Reboot the charger after changing the parameter.
Contact support
Office | Web form | Phone | Hours | |
General | +38642064000 | |||
eMobility After-Sales (SLA / self-service portal) |
You can also reach Plugchoice directly: chat with us in the app, or email [email protected].
For a complete guide, see our troubleshooting article if your charger can't connect to Plugchoice.