Requirements
A laptop at the charger, connected via USB-C cable or the same LAN network
Internet connection for the charger (LAN or SIM)
The login credentials below
Good to know: Blitz Power chargers don't use an OCPP URL. You select an OCPP provider from a list instead. Plugchoice is listed as Plugchoice.
Connect your charger
In the Blitz Power web interface:
Open http://ev3000.local:3000 in your browser.
Log in. Username:
operator. Password:blitzoperator91500591Select Quick Setup.
Go to Network.
LAN: select DHCP. Set the Gateway to your IP with the last number replaced by 1 (192.168.2.36 becomes 192.168.2.1).
SIM: leave SIM Pin blank, enter your SIM's APN, and save.
Go to Charge Points > Configure All.
Set Release Charging Mode to OCPP.
Set OCPP Provider to Plugchoice.
Copy the Charge Point Serial No. You need it in the next step.
Click Save.
Registering your charger in Plugchoice
Add the charger using the chargepoint ID. For Blitz Power, this is the Charge Point Serial No. (case sensitive).
Done! The charger should come online.
Troubleshooting
Did you set everything up correctly, but the charger still remains "Pre-registered"?
The chargepoint ID must exactly match the Charge Point Serial No.
Check Release Charging Mode is set to OCPP.
Check the Gateway ends in .1 when using DHCP.
Check the charger has internet (LAN cable or SIM signal).
For a complete guide, see our troubleshooting article if your charger can't connect to Plugchoice.