Requirements
A laptop and a USB cable (mini USB)
Windows only: CCU drivers installed before you start
Internet connection for the charger
Connect your charger
Connect the USB cable to the controller board's mini USB port.
Open a browser and go to http://192.168.7.2
Log in with username ccu, password ccu.
Go to Configuration > Setup and enable Advanced settings.
No internet yet? Set it up under the Interface tab.
Go to Configuration > Backend.
Leave Chargebox Identity unchanged. Note it down.
Set Communication Protocol to OCPP-J 1.6.
Set Backend Endpoint to ws://proxy.plugchoice.com/v1
Click Save.
On the General tab, enable RFID lock. Click Save.
Under Outlets, set Authentication Mode to RFID. Click Save.
Reset the charger.
On the Status page, check Backend connection is established.
Registering your charger in Plugchoice
Add the charger using the chargepoint ID. For CTEK, this is the Chargebox Identity (case sensitive).
Done! The charger should come online.
Troubleshooting
Did you set everything up correctly, but the charger still remains "Pre-registered"?
The chargepoint ID in Plugchoice must exactly match the Chargebox Identity (case sensitive).
On the Status page, WAN connection and Backend connection must both be established.
Check RFID lock is enabled and Authentication Mode is RFID.
Reset the charger after every change.
For a complete guide, see our troubleshooting article if your charger can't connect to Plugchoice.