Requirements
Charger connected to your home network
A computer or phone on the same network
The charger's admin password (request it from your current operator, for example Shell Recharge)
Connect your charger
Open your router's admin page (often
192.168.1.1,192.168.0.1or192.168.178.1).Open the list of connected devices (often called Connected devices or DHCP clients).
Find the charger. It may show as Shell, EV charger or only a MAC address.
Note the charger's IP address, for example
192.168.1.37.In a browser, open
http://[charger IP]:12800/admin/admin.html.Log in with the admin password.
Paste
ws://proxy.plugchoice.com/v1in the backend (central system) URL field.Save the settings.
Restart the charger.
The charger now connects to Plugchoice. This can take a few minutes.
Registering your charger in Plugchoice
Add the charger using the chargepoint ID. For NewMotion, this is the serial number, also shown in the admin interface (case sensitive).
Done! The charger should come online.
Troubleshooting
Did you set everything up correctly, but the charger still remains "Pre-registered"?
The chargepoint ID in Plugchoice must exactly match the serial number.
No admin password? Only your current operator can provide it.
Charger not in the router's device list? Check its network connection.
Changed the URL? Restart the charger.
For a complete guide, see our troubleshooting article if your charger can't connect to Plugchoice.